GENO-therm® Filling Device – heating system filling Basic

GENO-therm® filling devices are used for the simple initial filling and make-up water feed for closed heating systems. A disposable GENO-therm® cartridge or reusable GENO-therm® cartridge should be connected for this purpose. The filling device supports applicable standards (e.g. DIN EN 1717, DIN 14868). The Basic filling device made of brass consists of, among other components, a pre-filter, shut-off valves, a system separator, pressure reducer with pressure gauge, setting scale and analogue water meter. The GENO-therm® filling device can be subjected to pressures of up to 10 bar, the maximum water temperature is 65 °C, and the nominal connection diameter is DN 15.

  • Supports applicable standards e.g. DIN EN 1717, DIN 14868
  • Made of dezincification-resistant brass
  • Installation: horizontal pipe only

Installation requirements

Please observe local installation directives, general guidelines and technical specifications. The installation site must be accessible for maintenance work, flood and frost-proof and ensure that the system is protected from chemicals, dyes, solvents and vapours. The ambient temperature as well as the radiation temperature next to the system must not exceed 40 °C.

Scope of supply

GENO-therm® Basic filling devices consisting of

  • Pre-filter, shut-off valves
  • Pressure reducer with pressure gauge
  • Setting scale and with integrated maintenance slide
  • Analogue water meter
  • Bleed valves and preformed insulation
  • Screw connections with seals
  • Wall bracket

For further information on installation requirements and scope of supply, as well as technical details, see the product data sheet, which is available to download.